Mazda 6 2011 Manual page 306

Mazda6_8BG7-EC-10H_Edition1 Page306
Monday, August 2 2010 1:28 PM
Interior Comfort
Bluetooth Audio (Type A)
NOTE
Always perform Bluetooth audio device
l
programming while the vehicle is stopped.
If a Bluetooth device has already been
l
programmed to the vehicle as a hands-free
mobile phone, it does not need to be
programmed again when using the device
as a Bluetooth audio device. Conversely, it
does not need to be programmed again as a
hands-free mobile phone if it has already
been programmed as a Bluetooth audio
device.
Look around to be sure other likely
l
Bluetooth audio devices are not in range
when you start to program. If in doubt,
move your car to another location. The
transmission range of a Bluetooth audio
device is about 10 m (32 ft). Therefore, if
there is another Bluetooth audio device
within a 10 m (32 ft) radius of the vehicle,
the device may be identified and
programmed instead.
Device registration can also be done using
l
voice recognition (page 6-101).
Concerning the operation of a Bluetooth
audio device itself, refer to its instruction
manual.
Some Bluetooth audio devices have PIN
codes (four digits). Refer to the audio
device's instruction manual because the
programming procedure differs depending
on whether it has a PIN code or not.
Programming a Bluetooth audio device
which has a four-digit PIN code
1. Using the audio control dial, select the
pairing program mode
PAIR DEVICE in the BT SETUP
mode. (Refer to
Bluetooth audio device set-up for
details.)
6-82
Form No.8BG7-EC-10H
2. Press the audio control dial to
determine the mode.
After ENTER PIN is displayed on
the information display for three
seconds, PIN 0000 is displayed and
the PIN code can be input.
3. Input the PIN code of your Bluetooth
audio device by pressing channel
preset buttons 1 to 4 while PIN 0000
is displayed.
Press channel preset button 1 to input
the first digit, 2 for the second, 3 for
the third, and 4 for the forth. For
example, if the PIN code were 4213 ,
press channel preset button 1 four
times (1, 2, 3, 4), button 2 twice (1, 2),
button 3 once (1), and button 4 three
times (1, 2, 3). If the PIN 0000
display disappears before finishing the
PIN code input, repeat the procedure
from Step 1.
NOTE
Some devices accept only a particular pairing
code (Usually, "0000" or "1234").
If pairing cannot be completed, refer to the
owner's manual of your mobile device, and try
those numbers if necessary.
4. Press the audio control dial while the
input PIN code is displayed.
PAIRING flashes on the display.
5. Operate the Bluetooth audio device and
set it to the program mode while
PAIRING is flashing.
6. When the programming is completed,
and PAIR SUCCESS are
displayed after about 10-30 seconds,
after which PAIR SUCCESS
continues to be displayed for three
seconds, and then the unit returns to the
normal display.