Initializing Using Ftp Client - Canon LBP6310dn Manual

07K5-05E

Initializing Using FTP Client

1
Run Command Prompt.
)URP WKH >6WDUW@ PHQX VHOHFW >$OO 3URJUDPV@ RU >3URJUDPV@
2
Enter "ftp <the IP address of the printer>", then press the [ENTER] key on your keyboard.
Input Example: "ftp 192.168.0.215"
If you are not sure about the IP address of the printer
Refer to Network Status Print (
3
Enter "root" as the user name, then press the [ENTER] key on your keyboard.
4
Enter the administrator password, then press the [ENTER] key on your keyboard.
If the administrator password is not specified yet, do not enter any value, but press the [ENTER] key on your keyboard.
5
Enter "get defaults", then press the [ENTER] key on your keyboard.
The defaults file (the list of the default values of the network settings) is downloaded.
6
Enter "put defaults CONFIG", then press the [ENTER] key on your keyboard.
7
Enter "get reset", then press the [ENTER] key on your keyboard.
After completing the reset, the network settings are initialized.
8
Enter "quit", then press the [ENTER] key on your keyboard.
>$FFHVVRULHV@
"Checking the Printer Settings") or ask your network administrator.
>&RPPDQG 3URPSW@