Table of Contents
Advertisement
If you do not want to use the SNMP v. 3 protocol
Set [SNMP v. 3] to [Off].
If the SNMP v. 3 protocol settings are not displayed
If you change the settings for the SNMP v. 3 protocol using software other than the Remote UI, the settings are not
displayed in the Remote UI.
To display the settings again, reset the network settings to the default values.
"Initializing the Network
6
Select the [Restrict SNMP Monitoring/Setting Changes] check box.
7
Select [Permit Specified Addresses] or [Reject Specified Addresses].
[Permit Specified Addresses]
[Reject Specified Addresses]
8
Set the IP address.
(1) Enter the IP address of a computer for which you permit or reject monitoring and changing the settings using the
SNMP protocol.
Settings"
Only users specified in [IP Addresses] can monitor and change the settings.
Users specified in [IP Addresses] cannot monitor and change the settings.
Advertisement
Table of Contents
