Configure Ethernet Lldp - NETGEAR WAC720 User Manual

ProSAFE Dual-Band Wireless AC Access Points WAC720 and WAC730
5. Specify the settings as described in the following table.
Setting
Spanning Tree Protocol
Spanning Tree Protocol Select the Enable radio button to enable STP to prevent path redundancy. By
802.1Q VLAN
Untagged VLAN
Management VLAN
WARNING:
Selecting the Untagged VLAN check box or changing the untagged
VLAN value causes loss of IP connectivity if the hubs and switches
on your LAN are not yet configured with the corresponding VLAN.
6. Click the Apply button.
Your settings are saved.

Configure Ethernet LLDP

Link Layer Discovery Protocol (LLDP), IEEE 802.1ab, is a management tool that delivers
link-layer messages to adjacent network devices. For example, LLDP messages enable
networking devices such as switches and management tools to discover the access point in
the network, and might indicate whether the access point receives power through a PoE
connection. LLDP is inter-vendor compatible. By default, LLDP is enabled on the access
point.
Description
default, the Disable radio button is selected.
Select the Untagged VLAN check box to configure one VLAN as an untagged
VLAN. By default, the Untagged VLAN check box is selected.
Specify a VLAN ID. The default VLAN ID is 1.
Specify an ID for the VLAN from which the access point can be managed. The
default VLAN ID is 1.
If you configure the management VLAN ID as 0 (zero), the access point can be
managed over any VLAN, and frames that belong to the management VLAN are
not tagged with an 802.1Q header when sent over the trunk.
Advanced Configuration
98