Configure Ethernet Lldp - NETGEAR WAC730 Reference Manual

ProSAFE Dual-Band Wireless AC Access Point WAC720 WAC730
Setting
802.1Q VLAN
Untagged VLAN
Management VLAN
WARNING:
Selecting the Untagged VLAN check box or changing the untagged
VLAN value causes loss of IP connectivity if the hubs and switches
on your LAN have not yet been configured with the corresponding
VLAN.
3. Click Apply to save your settings.

Configure Ethernet LLDP

Link Layer Discovery Protocol (LLDP), IEEE 802.1ab, is a management tool that delivers
link-layer messages to adjacent network devices. For example, LLDP messages enable
networking devices such as switches and management tools to discover the wireless access
point in the network, and might indicate whether the wireless access point receives power
through a PoE connection. LLDP is inter-vendor compatible.
By default, LLDP is enabled on the wireless access point.
To turn off LLDP:

1. Select Configuring > System > Advanced > Ethernet LLDP.
2. Select the Disable radio button.
By default, the Enable radio button is selected.
Description
Select the Untagged VLAN check box to configure one VLAN as an untagged
VLAN. By default, the Untagged VLAN check box is selected.
Specify a VLAN ID. The default VLAN ID is 1.
Specify an ID for the VLAN from which the wireless access point can be
managed. The default VLAN ID is 1.
Note: If you configure the management VLAN ID as 0 (zero), the wireless access
point can be managed over any VLAN, and frames that belong to the management
VLAN are not tagged with an 802.1Q header when sent over the trunk.
Advanced Configuration
75