Configure The Ipv4 Settings - NETGEAR WAC720 User Manual

ProSAFE Dual-Band Wireless AC Access Points WAC720 and WAC730

Configure the IPv4 Settings

Note: For information about how to configure the IPv6 settings, see
Configure IPv6 Settings
WARNING:
If you enable the DHCP client, the IP address of the access point
changes when you click the Apply button, causing you to lose your
connection to the access point. You must use the new IP address to
reconnect to the access point.
Tip: If you enable the DHCP client on the access point, you can discover
the new IP address of the access point by accessing the DHCP server
on your LAN, or by using a network IP address scanner utility.

To configure the IPv4 settings:
1. Open a web browser from a computer that is connected to the same network as the
access point or to the access point directly through an Ethernet cable.
For more information, see
2. In the address bar, enter the IP address of the access point.
A login window opens.
3. Enter the user name and password.
The user name is admin. The default password is password. The user name and
password are case-sensitive.
4. Select Configuration > IP > IP Settings.
on page 95.
Log In to the Access Point
Initial Setup
21
on page 15.