Multitech CommPlete MR9600 User Manual page 44

MR9600 User Guide
e1cfg
Parameter: Device
Description: Sends E1 configuration information stored in nonvolatile memory to the specified device.
The specified device must be an E1 device. E1 devices can exist only at 1b, 1c, 5b, 5c, 9b, 9c, 13b, and 13c.
Security: Operator
Example:
[0] A:\MMM # e1cfg 13b
e1channelstatus, e1chstatus
Parameter: Device
Description: Displays the status of all the channels for the given E1 device.
Security: Guest
Example:
[0] A:\MMM # e1chstatus 13b
Channel
1
3
5
7
9
11
13
15
17
19
21
23
25
27
29
CO - Central Office, * - Inconsistent State
e1setup
Parameter: Device
Description: Sets the E1 configuration information associated with an E1 device. This information is
stored in a nonvolatile area of memory so that the device can be properly reconfigured on power-up or
reset. The specified device must be an E1 device. E1 devices can exist only at 1b, 1c, 5b, 5c, 9b, 9c, 13b, and
13c.
Security: Supervisor
Example:
[0] A:\MMM # e1setup 13b
Use settings from:
Enter Selection
Getting E1 Card Info ...
1. Channel Polling Interval (Sec):20
2. Error Threshold
3. Disconnect Timeout (sec) :11
36
CO Modem
On Hook On Hook
On Hook On Hook
On Hook On Hook
On Hook On Hook
On Hook On Hook
On Hook On Hook
On Hook On Hook
On Hook On Hook
On Hook On Hook
On Hook On Hook
On Hook On Hook
On Hook On Hook
On Hook On Hook
On Hook On Hook
On Hook On Hook
1. Use Active Settings (pre-configured card)
2. Use System Defaults (new card)
3. Use Stored Settings (swapping cards)
(q(uit), <1>):
OOS Channel CO
2 On Hook
4 On Hook
6 On Hook
8 On Hook
10 On Hook
12 On Hook
14 On Hook
16 On Hook
18 On Hook
20 On Hook
22 On Hook
24 On Hook
26 On Hook
28 On Hook
30 On Hook
1
:10
Modem OOS
On Hook
On Hook
On Hook
Timeout
On Hook
On Hook
On Hook
On Hook
On Hook
On Hook
On Hook
On Hook
On Hook
On Hook
On Hook
CommPlete Communications Server