Hitachi C 10FCH2 Technical Data And Service Manual page 47

Item
Phenomenon
3 Saw blade is locked.
Saw blade does not
4
rotate when switch is
triggered.
Saw blade runs too
5
slow (not within
4,500 --- 5,500 min
Cause
a Excessively fast
cutting speed
b Core diameter of
extension cord is too
small.
c Excessive cutting force
is applied due to dull
saw blade.
d Incorrect saw blade is
used.
e The saw blade binds in
workpiece during
cutting because
workpiece is warped
or bent.
a The power cord is not
connected to power
supply.
b The carbon brush
wear exceeds
allowable limit (5 mm).
c Contact failure of the
switch ass'y
a Power supply voltage
is lower than rated
-1 ).
voltage.
Factory
standard
------
------
------
------
------
------
------
------
------
--- 44 ---
Inspection, repair or
adjustment
• Reduce cutting speed.
• Use a thicker and shorter
extension cord.
• Resharpen the saw blade.
• Use a suitable Hitachi-supplied
saw blade.
• If the saw blade has a large
number of teeth, the cutting
resistance will be increased.
When using a saw blade with a
large number of teeth, reduce
the cutting speed.
• Correct workpiece deformation
with a planer.
• Check power supply voltage.
• Connect the power cord to
power supply.
• Check the Carbon Brushes
[182] for wear.
• Replace the Carbon Brushes
[182].
• Check the Switch (3P Faston
Type) W/O Lock [166] for
conductivity.
• Replace the Switch (3P Faston
Type) W/O Lock [166].
• Check power supply voltage.
• Check if extension cord is
appropriate.