No-Load Current; Reassembly Requiring Adjustment - Hitachi C 10FCH2 Technical Data And Service Manual

11-5. No-load Current

After no-load operation for 30 minutes, the no-load current values should be as follows.
Voltage, frequency
No-load current

11-6. Reassembly Requiring Adjustment

(1) Adjustment of squareness between the saw blade (dummy disc) and the fences
Fence (B)
Square
(2) Reassembly of the Turn Table [36]
When reassembling the Turn Table [36] and the
Base Ass'y [67], tighten the Nylon Nut M8 [28] so
that the Turn Table [36] turns smoothly without
excessive play or vibration. During reassembly,
liberally apply grease (Hitachi Motor Grease) at
the point marked "A" in Fig. 37.
110 V, 120 V
7 0.8 A
Fence (A)
Saw blade or
dummy disc
Fig. 36
220 V, 230 V
4.3 0.5 A 4.0
After disassembly or replacement of the Base Ass'y [67],
Turn Table [36], Fence (A) [65], Fence (B) [54] or Hinge
[16], it is necessary to perform adjustment to ensure that
the fences are positioned at precise right angles with
relation to the saw blade (or dummy disc). Align fence (B)
with the saw blade (or dummy disc), and adjust them as
necessary to ensure squareness (tolerance: 0.4/100 mm).
As shown in Fig. 36, use a square to set fence (B) square
to the saw blade. Next, use a straight edge to adjust fence
(A) so that it is exactly aligned with fence (B). Finally, use
the square to confirm squareness of fence (A) with the saw
blade (tolerance: 0.4/100 mm).
A
Shaft (B) [66]
--- 34 ---
240 V
0.5 A
Nylon Nut M8 [28]
Turn Table [36]
Base Ass'y [67]
Fig. 37