Replacing The Squeegee Blades; Disassembly Of The Brushes; Cleaning The Battery Compartment - Pacific Proteus 26 Operating & Maintenance Instructions

REPLACING THE SQUEEGEE BLADES

Check the squeegee blades for wear and if necessary, change them.
To replace the squeegee blades:
1. Remove the squeegee hose from its coupling.
2. Push on the rocker arm and loosen the stud bolt.
3. Remove the squeegee from its support.
4. Loosen the wing nuts (1) that lock the rubber blades and take them off.
5. Replace the blades.
6. To reassemble the squeegee, repeat the above operations inversely.

DISASSEMBLY OF THE BRUSHES

1. Lift the brush base with lever (1).
2. Set the brake lever (2).
3. Turn the key to the OFF position and remove it from the switch.
4. Unhook the splash guards on the brush base.
5. Rotate each brush until it comes off from the brush plate seat. The figure
shows the rotating direction for the disassembly of the right brush, the
left one has to be rotated inversely.

CLEANING THE BATTERY COMPARTMENT

Use the hose under the solution tank, which is accessible from the rear of the ma-
chine to empty any liquids from the battery compartment.
WARNING! Use gloves for protection from contact with
dangerous solutions. Danger of emission of corrosive liquids!
FIRE DANGER: Do not approach with open flames!
DAILY MAINTENANCE
17