Table of Contents
Advertisement
After finishing your work and before any type of maintenance is done, it is neces-
sary to do the following:
1. Close the water valve through lever (1).
2. Raise the brush base with lever (2).
3. Lift the squeegee with lever (3). Note: The squeegee blades can be damaged
if the squeegee is not raised during storage or transport.
4. Switch off the solenoid valve switch (1).
5. Switch off the brush switch (2).
6. Switch off the vacuum motor switch (3).
7. Transport the machine to the location where the recovery tank should be emp-
tied.
8. Turn the key (4) OFF.
9. Set the parking brake.
10. Pull out the hose on the front part of the recovery tank.
11. Unscrew the drain plug and empty the recovery tank.
WARNING! Use gloves for protection from contact with dangerous
solutions.
12. Remove the brush and clean it with water (refer to the section "Disassembly of
the Brush").
UPON COMPLETION OF THE WORK
15
1
3
2
Advertisement
Table of Contents
