Text Is Not Printed Properly; The Printed Label Is Not Cut Automatically; Printing Stops In The Middle Of The Text - K-sun BEE3 Owner's Manual

Have the batteries run out?
When the batteries are running out,
"Change Batteries" appears on the display.
Replace all the batteries with new AA
alkaline batteries immediately or connect
the AC adapter that comes with the device,
otherwise the LABELShop
turn off in the middle of the operation or
during printing.
Is top cover closed?
Printing is not carried out if the top cover is
opened. Install tape cartridge correctly,
and close the top cover completely.
See "Installing tape cartridges"
(p.28).
Text is not printed
properly
Is the tape cartridge installed
correctly?
Remove the tape cartridge and reinstall it
again following the correct procedure.
See "Installing tape cartridges"
(p.28).
Is the printhead free from dirt?
Printing becomes faint when dirt or dust
adheres to the printhead. Rub the
printhead with a cotton swab moistened
with medical alcohol (ethanol) available in
the market.
See "Cleaning LABELShop
(p.110).
A faint streaking
108
Appendix
£
BEE3 may
£
BEE3"
Is there any blank line on the label?
If an unnecessary margin is printed on the
label, a blank line is included.
In this case, place a cursor on the right
side of the line head icon (larger number)
using , and delete the
unnecessary line by pressing
See "Joining the two lines" (p.51).
Have the batteries run out?
When the batteries are running out,
"Change Batteries" appears on the display.
Replace all the batteries with new AA
alkaline batteries immediately or connect
the recommended AC adapter
otherwise the LABELShop
turn off in the middle of the operation or
during printing.
The printed label is not
cut automatically
Is the auto-cutter feature disabled?

The printed label is not cut automatically

when the auto-cutter feature is disabled.
See "Turning "Autocut" Off to
Print" (p.91).
Printing stops in the
middle of the text
Is the tape remaining in the tape
cartridge?
If the tape in the tape cartridge has run
out, replace the cartridge with a new one.
See "Installing tape cartridges"
(p.28).
Have the batteries run out?
When the batteries are running out,
"Change Batteries" appears on the display.
Replace all the batteries with new AA
alkaline batteries immediately or connect
the AC adapter that comes with the device,
otherwise the LABELShop
turn off in the middle of the operation or
during printing.
.
£
BEE3 may
£
BEE3 may