Printing Label - K-sun BEE3 Owner's Manual

5. Printing label

Before you start printing, make sure that the tape cartridge is correctly installed and
the AC adapter is connected properly.
1 Press
Expected length of the label will be displayed after
"Wait" appears. Printing is started subsequently.
LABELShop £ BEE3 automatically cuts the tape when the printing is completed. To
cancel the printing, press
x When you press
x When you print the same label repeatedly, the total number of the printed labels will
appear on the screen.
x The total number of the printed labels returns to "1" when you change or modify the text
(characters or the style). The number is counted up to "100", then returned to "1".
x LABELShop £ BEE3 makes sounds when ejecting tapes. This is normal operation for the
device.
x Backing sheet of tape sometimes cannot be sharply cut off. However, this does not
adversely affect the label itself.
x Time before the printing starts may become longer if you entered complex texts.
x Do not insert your fingers in the tape eject slot.
x Do not pull the tape until the printing is completed.
x Do not open the top cover during printing. Doing so cause an improper printing.
x Make sure that the ejected tape does not block the tape ejection slot.
x "No Tape!" will appear on the screen if the tape cartridge is not installed or not installed
properly.
x When you entered too many lines of text to be printed on the tape, "Line Over!" will
appear on the screen. In that case, delete some lines or install a wider tape.
x Length of the label shown on the screen is a guide and may not match the length of the
printed label exactly.
40
Basic Operations 1
.
.
during printing, the device cuts the tape and turns the power off.
Auto 1.7"
1