Table of Contents
Advertisement
K K e e y y P P r r e e ss ss A A l l e e r r t t
A short tone or "beep" sounds to indicate a key has been
pressed. A short low-pitched tone indicates no action was
taken because the key is not active in the current mode.
T T U U R R N N I I N N G G O O N N T T H H E E R R A A D D I I O O
Rotate the POWER ON-OFF/VOLUME knob clockwise, out of
detent to turn the radio on. (Ensure the antenna and battery
pack are properly connected prior to power on.) A short beep (if
enabled through programming) indicates the radio is ready for
operation. The display indicates, if programmed, the last se-
lected system name on line one and the last selected group or
channel name on line two.
In the EDACS trunked environment, upon acquisition of the
control channel,
system' s control channel cannot be established,
turn on. This may occur if, for example, the radio is out of range
of the trunking site. It may be necessary to move to another
location or select another trunking system to reestablish the
control channel link for trunked mode operations.
S S E E L L E E C C T T I I O O N N M M O O D D E E R R U U L L E E S S
Many operations require selection from a list such as sys-
tem, group or phone number. This selection process is handled in
the same manner for all lists.
the CLEAR/MONITOR button are used during the selection
process. The following example systems list is used to explain
the process:
2 2 4 4
O O P P E E R R A A T T I I O O N N
will come on. If communication with the
,
S S V V C C
,
,
,
.
m
will not
, and
o
Advertisement
Table of Contents
