Status Operation - Ericsson EDACS M-RK-II SCAN Operator's Manual

STATUS OPERATION

Status operation permits the transmission of a pre-pro-
grammed status condition to the EDACS site.
To send a status condition, press the
or
, .
status has been programmed for the selected number key, the
radio will display
"NO ENTRY". A valid selection will permit the status text to
appear in the display for a pre-programmed time. After the
time-out expires or the
key will override the time-out period), the status is selected and
will be transmitted to the site or stored in the radio memory
where it can be polled by the site at a future time. If the site does
not receive the status properly, the radio will sound a low
pitched tone.
The status selection can also be cancelled by pressing the
CLEAR button prior to the time-out period.
To view the currently selected status after it has been
transmitted, press the
ramp to STS, re-press the
button prior to the time-out period. If the status was not sent
successfully to the site, the text associated with the status
will flash in the display.
STATUS OPERATION
key to select the pre-programmed status. If no
m
m
m
m
key has been pressed (the
key and then the
key again and then the CLEAR
key followed by
m
key to
,
6 6 5 5