Edacs Conventional P1 Scan - Ericsson EDACS M-RK-II SCAN Operator's Manual

This feature permits the radio user to scan a pre-pro-
grammed conventional system and channel as a Priority 1 (P1)
channel while the radio is selected for EDACS trunked system.
If activity is detected on the conventional P1 channel, the radio
will unmute and remain on this conventional channel for the
programmable hang time.
The radio must be pre-programmed to designate a key for P1
scan on/off operation.
Dynamic group operation permits multiple talk groups (up to
eight) to be added to a radio via the system manager. The radio
must be pre-programmed to respond to regrouping. Dynamic
regrouping will not be activated in a radio until an activation
message is sent by the system manager. Each radio that re-
ceives and acknowledges the regrouping instructions is suc-
cessfully regrouped.
Pressing and holding the CLEAR/MONITOR button for 2.5
seconds toggles the user into and out of the dynamic regroup
groupset. A double beep will sound for entry or exit. The display
will indicate "REGRP_0x" where "x" is a digit of 1 to 8 indicating
the group when dynamic regroup has been enabled by the user.
If the radio is in dynamic regroup and the user selects a group
that has not been regrouped, the display will show "NO ENTRY".
The radio will be prevented from transmitting and receiving calls
in this condition except for scanned groups.
66 66

EDACS CONVENTIONAL P1 SCAN

D D Y Y N N A A M M I I C C R R E E G G R R O O U U P P O O P P E E R R A A T T I I O O N N