Scan Alert Tone; Priority-One (P1) Scan; Radio/Channel Failure; Operation - Ericsson KPC-300 Operator's Manual

Portable radio unit

Hide thumbs Also See for KPC-300:

Table of Contents

delay before voice transmission begins. If the alert tone

is disabled, no beep will sound.

Scan Alert Tone

The radio will sound a beep when the

pressed.

If the Priority 1 alert tone is enabled by programming

and the radio receives a signal on the Priority 1 channel

when scanning, the radio will sound a beep.

The simultaneous flashing of the LCD display and the

sounding of beeps indicates the synthesizer is unable to

correctly lock on the selected channel. At this time the

radio changes to a mute condition and no audio is heard

from the speaker when receiving and the transmit is

inhibited if the PTT button is pressed. Select another

channel, change the battery pack or have the radio

repaired.

1. Turn the radio on by rotating the ON/OFF/VOLUME

control clockwise from the "off" detent. After the radio

has successfully completed its power-up self-test, it

will begin operation at the last operating state (chan-

nel, etc.). The operating status of the radio will be

button is

Table of Contents

Kpc-400