Operation; Receiving A Message - Ericsson PCS Operator's Manual

hibited (no transmission is made). Select another chan-
nel, change the battery pack, or have the radio repaired.

RECEIVING A MESSAGE

1. Turn the radio on by sliding the ON/OFF switch
on the battery pack to the "ON" position. A yellow
area will be visible. After the radio has success-
fully completed its power-up self-test, it will begin
operation at the last operating state (channel,
volume, etc.). The operating status of the radio
will be displayed in the LCD window. If pro-
grammed on, the power-up alert tones (three or
four beeps) will be sounded.
2. Select the desired operating channel by pressing
the CHANNEL UP or CHANNEL DOWN buttons.
The channel number will be displayed in the LCD
window.
3. When a message is received (and the correct
Channel Guard or Type 99 signal is decoded, if
programmed and enabled), the receiver will un-
squelch and the message will be heard in the
speaker.
4. Adjust the volume as necessary.

OPERATION

25