•
1200 Hz Tone
–
•
2500 Hz Tone
–
OPERATION
POWER-UP
After the battery pack and antenna have been
installed, turn the radio on by sliding the ON/OFF
SWITCH on the battery pack up. After the radio
has completed a power-up self-test, it will begin
operation on the last operating state as displayed
in the LCD. If programmed on, the power-up alert
tone (beep) will be heard.
If the radio was previously operating in a
trunking system and communication with this sys-
tem's control channel cannot be established, the
NC status flag will turn on. This may occur if, for
private mode channel ac-
cess tone - sounds when
the radio is in the private
transmit mode, a trunked
channel has been as-
signed and it is clear to
talk.
call queued tone - sounds
when a trunked call is
queued.
example, the radio is out of range of the previous
trunking site. It may be necessary move to an-
other location, select another trunking system, or
a conventional channel.
SYSTEM/GROUP/CHANNEL SELECTION
The radio may be programmed with one of
two different system/group/ channel selection
modes as follows:
•
Systems are selected with the
groups and channels are selected with the
CONTROL KNOB.
S
•
Systems are selected with the CONTROL
KNOB; groups and channels are selected
with the
key.
S
key;
or
13