Table of Contents
Advertisement
•
800 Hz Tone
–
•
1000 Hz Tone
–
–
•
1200 Hz Tone
–
•
2500 Hz Tone
–
private mode disabled -
on a conventional chan-
nel, sounds when the PTT
BUTTON is pressed if pri-
vate transmit mode has
previously been disabled.
alert tone - sounds when
a button is pressed and a
status change occurs
channel access tone -
sounds when a trunked
channel has been as-
signed and it is clear to
talk.
private mode channel ac-
cess tone - sounds when
the radio is in the private
transmit mode, a trunked
channel has been as-
signed and it is clear to
talk.
call queued tone - sounds
when a trunked call is
queued.
OPERATION
POWER-UP
After the battery pack and antenna have been
installed, turn the radio on by sliding the ON/OFF
SWITCH on the battery pack up. After the radio
has completed a power-up self-test, it will begin
operation on the last operating state as displayed
in the LCD. If programmed on, the power-up alert
tone (beep) will be heard.
If the radio was previously operating in a
trunking system and communication with this sys-
tem's control channel cannot be established, the
"NC" status flag will turn on. This may occur if, for
example, the radio is out of range of the previous
trunking site. It may be necessary move to an-
other location, select another trunking system, or
a conventional channel.
13
Advertisement
Table of Contents
