Gemini Hub - Gemini 720is Product Manual

Gemini Software Operation

5.3.2. Gemini Hub

Hubs Tab
The Hubs tab shows the status information from any connected Gemini Hubs.
Hub Setup Tab
The Hub Setup tab allows configuration of the serial ports on the rear of the Gemini Hub to
allow RS232 data to pass through to the Gemini software from external sensors.
Port
Mode
Sync
Document: 0703-SOM-00002, Issue: 1
Note
The Settings field of the Sensors tab is only active if logging is taking place.
Within the Settings field the actions of the operator are recorded so that during
play back of the log file it is possible to see which settings have been changed.
Note
If serial sensor data is shown here, a subset of the data will also be shown at
the bottom of the User screen.
The port letter, corresponding to the label on the back of the Gemini
Hub.
Can change between an ASCII decode, binary decode or can echo
the data on one of the other ports (ASCII is the default input, only the
Simrad EM3000 uses a binary input). Echo is used as an alternative to
a serial splitter cable in systems where the sensor data is also used by
another application or device.
The sync character used to frame the ASCII string.
47
Gemini 720is Imaging Sonar
© Tritech International Ltd.