Check The Operation Of The Gemini - Gemini 720is Product Manual

Gemini Software Installation

4.3.1. Check the operation of the Gemini

If the correct changes have been made to the Gemini it should now show as connected in
the Gemini software. If nothing is displayed, check that all values entered were correct and
it may be necessary to rerun the Gemini software to establish a link. The Gemini software
retains its settings between runs, and so all the values which were used whilst the Gemini
was programmed will be retained.
When the Gemini software is started, select the Advanced tab to show details of the
connected Gemini and if it is able to communicate, it will be listed in the status window and
automatically go online after five seconds.
Document: 0703-SOM-00002, Issue: 1
Note
For instructions on setting the computer and Gemini IP address please refer to
Appendix A, Setting the computer IP address in Windows XP or Appendix B,
Setting the computer IP address in Windows 7 and Appendix C, Setting the
Gemini Device IP Address in Gemini Software.
25
Gemini 720is Imaging Sonar
© Tritech International Ltd.