Setting The Gemini Head Ip Address In Seanet Pro - Gemini 720is Product Manual

Appendix D. Setting the Gemini Head IP Address in
Seanet Pro
Run Seanet Setup and click on Gemini LAN in the Setup menu.
This will open the Gemini LAN Setup dialog.
Ensure that the Gemini is connected directly to the computer.
In the Selected Sonar drop-down control, ensure that the correct Gemini is selected. The
current Sonar IP Address and Subnet Mask are displayed on the left hand side of the
form. These are the settings the selected Gemini is currently programmed with.
In the Modify Network Address using... panel on the right hand side, update New IP
Address and/or New Subnet Mask. The text box background colour will change from white
to red to indicate a change has been made, as shown below.
Once these details have been entered, pressing the OK button will start the process of
changing the IP address. A dialog box will open, requesting confirmation from the user, the
box looks like this.
Check that the change details have been entered correctly and click on the OK button to
accept.
The Gemini node Status will change to Unknown whilst the new details are being
programmed into the Sonar. This will take a few seconds.
When the programming is finished the it may be necessary to reset the computer IP address
to enable communication to resume with the Gemini (see the section Setting the Computer
Document: 0703-SOM-00002, Issue: 1 76
Gemini 720is Imaging Sonar
© Tritech International Ltd.