Check The Operation Of The Gemini - Gemini 720i Product Manual

Gemini Software Installation
been delivered from the factory. If the IP address of Gemini has already been changed, an
appropriate address for the computer will need to be selected first to allow communication
with the Gemini before it can be configured.
The Gemini head should be given an IP address appropriate for the network it will be running
on. The address at manufacture is 192.168.2.201 and the process of setting the sonar IP
address involves talking to the unit via the 192.168.2.201 address to change the IP address
to a value suitable for the network.

4.3.1. Check the operation of the Gemini

If the correct changes have been made to the Gemini it should now show as connected in
the Gemini software. If nothing is displayed, check that all values entered were correct and
it may be necessary to rerun the Gemini software to establish a link. The Gemini software
retains its settings between runs, and so all the values which were used whilst the Gemini
was programmed will be retained.
When the Gemini software is started, select the Advanced tab to show details of the
connected Gemini and if it is able to communicate, it will be listed in the status window and
automatically go online after five seconds.
Document: 0685-SOM-00001, Issue: 11
Note
For instructions on setting the computer and Gemini IP address please refer to
Appendix A, Setting the computer IP address in Windows XP or Appendix B,
Setting the computer IP address in Windows 7 and Appendix C, Setting the
Gemini Device IP Address in Gemini Software.
25
Gemini Imaging Sonar
© Tritech International Ltd.