Table of Contents
Advertisement
[Viewer Setup]
[Unicast] Settings
You can set the HTTP port and the JPEG frame rate
in Unicast.
This page can be used during access using
"admin" or "operator".
When the Control Menu is open, click [Viewer
0
Setup] to switch to the Viewer Setup Menu.
Click [Unicast] to open the Settings screen.
0
When you click the [Apply] button, the current
0
settings are made valid on the viewer and they
are stored in the computer.
HTTP Port
You can change the port number to be used when
the client computer accesses to the camera via
HTTP.
Set to the same value as [HTTP Server Port] of the
[Protocol] page.
(A p.75 [[Protocol] Page] )
[Factory default: 80]
JPEG Frame Rate
Sets a frame rate for image acquisition by the
viewer.
A high frame rate increases the amount of data
processed by the computer where the viewer is
running.
[Set values: 30 fps, 15 fps, 10 fps, 7.5 fps, 6 fps,
R5 fps, 3 fps, 2 fps, 1fps, 1/2 fps, 1/3 fps, 1/5 fps,
1/10 fps, 1/15 fps, 1/20 fps, 1/30 fps, 1/60 fps]
Note :
Set the JPEG frame rate so that the CPU load of
0
the computer does not exceed 80 %.
If the CPU is overloaded, the computer may not
function properly.
The highest frame rate for images is the
0
camera's encoding setting.
(A p.52 [ Framerate ] )
[Viewer Setup] -[Unicast] Settings
99
Advertisement
Table of Contents
