Table of Contents
Advertisement
5 Mount the dome cover to the camera.
Use the screws (x4) to mount the dome cover
0
to the camera. When installing the dome
cover, make use of the three catches and the
center mark of the cover as a guide. Install
such that the central mark appears above the
JVC mark of the camera.
Center
mark
(facing the JVC mark)
Note :
Check that there is no dirt or dust inside the
0
dome cover before mounting.
When installing on a rainy day, ensure that
0
raindrops do not enter the interior.
When mounting the dome cover, temporarily
0
secure the four screws and then tighten.
As a guide, tighten the screws to 0.5 N·m to
0
1 N·m (5 kgf·cm to 10 kgf·cm). If the screws are
insufficiently tightened, the dome cover may fog
due to moisture penetration.
6 Remove the cable connection cap.
Remove the cap on the arm of the camera.
0
Cable
connection cap
Installation and Connection Preparations (VN-H657WPBU)
34
Position alignment catches (x3)
7 Pull out the cables from the cable
connection hole.
Pull out the cables (except the fall prevention
0
wire) of the camera from the cable
connection hole.
Preparation for installation and connection is
now complete. Next, mount the camera unit.
(A p.35 [Mounting the Camera
(VN-H657WPBU)] )
Advertisement
Table of Contents
