Table of Contents
Advertisement
[Audio] Page
This is a page for specifying the audio settings.
This page can be used during access using
"admin" or "operator".
Click [Advanced Settings] in the side menu, and
0
click [Audio].
Press the [OK] button to enable the new
0
settings.
If the [OK] button is pressed upon entering an
0
invalid value, a warning message will appear
and the entry will be denied. Press the [Cancel]
button to restore the invalid entry to the value
before the change was made. If you press the
[Cancel] button, other changed items will also be
restored to the values before the change was
made.
Settings
* Setting values with R are default values.
Audio
Communicate
For setting the audio transmission mode.
Half Duplex:
0
Stops the audio transmission from the camera
to the computer during audio transmission from
the computer to the camera.
Full Duplex:
0
Enables audio transmission from the computer
to the camera while listening to audio sent from
the camera to the computer.
[Set values: RHalf Duplex, Full Duplex]
Memo :
When "Full Duplex" is selected, audio
0
transmission received from the computer may
be fed back to the computer through the external
microphone connected to the camera, causing
echo to occur. If this occurs, make use of the
"Half Duplex" setting.
Mike Gain
For setting the gain level for the external
microphone connected to the camera.
[Set values: 0dB, 20dB, 26dB, R32dB, AGC]
Mike Power Supply
For setting the power supply for the external
microphone connected to the camera.
[Set values: RON, OFF]
[Advanced Settings] Page -[Audio] Page
55
Advertisement
Table of Contents
