Bolt VX-760C User Manual page 45

When positioning wireless slaves to light a subject, keep in mind the following:
• The effective communication range between master
and slave flash units is approximately 33 feet (10 m) in
the front position, and approximately 23 feet (7 m) on
both sides. These ranges may vary, depending on the
ambient light.
• The flash head should not be aimed directly into the
camera lens.
• The wireless TTL sensor is located on the front of
the VX-760C. Make sure that the sensor is facing
the master flash and that there are no obstructions
between the two units.
• When photographing outdoors or in bright ambient
light, the sensors can be overwhelmed by ambient
light, which will lower their sensitivity.
• To avoid creating interference between flash units,
using more than three in a single group is not
recommended.
33'
16–23'
Positioning Slave Flash Units
| |
45 45