Bolt VX-760C User Manual page 41

Setting the slave mode: To set the VX-760C flash unit to
function as an automatic slave, follow these steps:
1. Make sure the master flash or controller on your camera is
on and set to automatic TTL or wireless manual mode.
2. Press and hold the MODE button until the wireless flash
mode icon ( ) and the channel and group settings appear
on the LCD.
3. Set the channel by pressing the SUB button to make the
channel number blink. Use the left and right navigation buttons to cycle through channel numbers 1–4.
When the desired channel number appears on the LCD, press the SUB button again to select it. The group
indicator will now blink.
4. Use the left and right navigation buttons to cycle through groups A–C. When the desired group appears on
the LCD, press the MODE button to select it.
5. If desired, adjust the zoom position by pressing the ZOOM button (see Controlling Flash Coverage on
page 27).
Note: The wireless ready indicator light will blink in slave mode.
Using Your VX-760C as a Wireless Master or Slave
Zoom
| |
41 41