Serviceable Components Of The Main Sub-Assemblies - Motorola APX 5000 Service Manual

Disassembly/Reassembly Procedures: Serviceable Components of the Main Sub-Assemblies
8.8

Serviceable Components of the Main Sub-Assemblies

8.8.1 Servicing Main Chassis Assembly (E)
Universal Connector Insert (17)
NOTE: For assembly, ensure the key feature
8.8.1.1 Servicing Coin Cell Pad:
1. Complete steps from
2. Carefully peel off the pad.
3. Use the Black Stick to help remove any difficult sections of the pad(s).
4. Clean the area once the pad is removed to ensure it is free of adhesive and debris.
5. Peel the liner off the new pad and place in the respective location.
6. Apply slight pressure to set the adhesive.
8.8.1.2 Servicing Universal Connector Insert:
1. Complete steps from
2. Ensure the locking tab is pressed and carefully slide the Universal Connector Insert (17) with
the Black Stick from the Main Chassis Assembly (15) as shown in
3. Press the new Universal Connector Insert until it is fully seated and the lock tab is engaged
on the chassis.
8.8.1.3 Servicing Antenna O-ring:
1. Complete steps from
2. Remove the O-ring (16) with the Black Stick.
3. Reinstall the O-ring by rolling it over the threaded portion of the antenna hub until it sets in its
groove.
NOTE: Ensure the O-ring is not twisted.
O-Ring (16)
RF Coax Cable (20)
is aligned as shown.
Figure 8-30. Serviceable Components – Main Chassis Assembly
Section 8.7.1.
Section 8.7.1.
Section 8.7.1.
Screws (44)
Chassis Ground Contact (18)
Coin Cell Pad (19)
through Section 8.7.9.
through Section 8.7.4.
through Section 8.7.9.
Main Seal (54)
of section 8.7 on page
of section 8.7 on page
Figure 8-30.
of section 8.7 on page
Sec 2: 8-21
2:8-13.
2:8-13.
2:8-13.