Disassembly/Reassembly Procedures: Radio Reassembly
5. Plug the Expansion Board Assembly (H) to the VOCON Board Assembly (D) as shown in
Figure 8-50.
6. Connect the two Flex Connectors to their pairing connectors on the right and left sides of the
Expansion Board Assembly as shown in
Control Top Support Pads
7. Insert the rounded portion of the Expanded Board Support (61) into the opening of the
vacuum test compartment on the expanded side as shown in as shown in
Rounded Portion
8. Ensure the Rounded portion of the Expander Board Support is secure properly before
rotating the Expander Board Support towards the Antenna Coax Connector.
9. Slide the Locking Feature of the Expander Board Support between the Antenna Coax
connector and the Chassis Wall.
Make sure the connector is fully engaged.
Flex Connectors
Figure 8-50. Insert Flex Connectors
Figure 8-51. Expander Board Support (61)
Figure 8-52. Insert Expander Board Support
Figure 8-50.
Expansion Board Assembly (33)
Locking Feature Portion
Capacitor to avoid
Rounded portion of
Expander Board Support
Sec 2: 8-37
Figure 8-52.