Disassembly/Reassembly Procedures: Radio Reassembly
4. Tuck in the Antenna Coax Cable into its grooves as shown in
5. Plug the Expansion Board Assembly (H) to the VOCON Board Assembly (D) as shown in
Figure 8-50.
6. Connect the two Flex Connectors to their pairing connectors on the right and left sides of the
Expansion Board Assembly as shown in
Control Top Support Pads
Flex Connectors
8.9.1.8 Assemble Speaker Module (J)
1. Ensure the Seal is free from any debris or foreign material.
2. Align the Speaker Module's Pin feature located on the bottom edge directly below the
speaker, into the hole on the chassis hook feature.
3. Swing the Speaker Module down and firmly press the top side into the radio as shown in
Figure 8-51.
Make sure the connector is fully engaged.
Figure 8-50. Insert Flex Connectors
Do not touch the speaker cone or the port seal. Take extra
precaution to make sure neither the speaker nor the breather
pad is damaged.
Figure 8-51. Insert Speaker Module
Figure 8-49.
Figure 8-50.
Expansion Board Assembly (33)
Speaker Cone
Pin Feature
Chassis Hook Feature
Sec 1: 8-37