Disassembly/Reassembly Procedures: Radio Disassembly
8.7.7
Removal of the VOCON Board Assembly (D)
NOTE: Reconfirm the Flex connector between the Control Top Assembly (F) and the
1. Ensure RF Board is removed (see
Board screw (45) (as shown in
enough to clear the Main Chassis. Slide out the VOCON Board Assembly
as shown in
VOCON Board Assembly (D) is disconnected. Failure to do so may damage the
connectors or the flex.
Figure
Figure 8-27.
Figure 8-26. Remove VOCON Board Screw
VOCON Board Assembly (D)
Figure 8-27. Remove VOCON Board Assembly
Section 8.7.6 on page
8-26.), Gently rotate the VOCON Board Assembly just
RF and VOCON Board Screw (45)
2:8-18.). Remove RF and VOCON
Sec 2: 8-19