Installing A Secondary 3.5-Inch Hard Drive - HP ProDesk 600 G2 Small Form Factor Maintenance And Service Manual

Installing a secondary 3.5-inch hard drive

CAUTION: All removable media should be taken out of a drive before removing the drive from the computer.
1. Prepare the computer for disassembly
2. Remove the access panel
3. Install four silver 6-32 mounting screws on the sides of the drive (two on each side).
NOTE:
primary 3.5-inch hard drive bay. Refer to
mounting screws.
When replacing a drive, transfer the four mounting screws from the old drive to the new drive.
4. Rotate the drive cage to its upright position
(Access panel on page
HP has supplied four extra silver 6-32 mounting screws installed on the chassis next to the
(Preparation for disassembly on page
20).
Drives on page 33 for an illustration of the location of the extra
(Rotating the drive cage on page
19).
32).
Drives 41