Pedal-Up Braking; Parking Brake; High Pedal Disable Feature; Starting And Driving - Cushman LSV 800 INTL Owner's Manual

Read all of SAFETY and this section before attempting any procedure. Pay particular attention to Notices, Cautions, Warnings and Dangers.
the throttle is increased. When the brake pedal is released the vehicle will slow down as it does with pedal up braking.

Pedal-Up Braking

Pedal-up braking is regenerative braking that occurs when the accelerator pedal is released while the vehicle is moving.
Example: If both of the following events occur:
a. The vehicle is being driven down a slope
b. The accelerator pedal is released
The pedal-up braking will slow the vehicle until the vehicle stops, or the accelerator pedal is applied. When pedal-up
braking system is activated by this sequence of events, the motor generates power that is returned to the batteries.

Parking Brake

In the event that the vehicle will not move in forward or reverse, the automatic parking brake can be released using the
instructions located on the controller splash shield beneath the seat on the passenger side of the vehicle. Refer to the
Maintenance Procedures section of this manual for in-depth instructions.

High Pedal Disable Feature

High pedal disable prevents acceleration if the key is turned on while the accelerator is pressed.

Starting and Driving

All vehicles have an interlock system that disables the controller and prevents operation of the vehicle while the charger
is connected. Remove the charger plug from the receptacle and correctly store the cable before you move the vehicle.
To operate the vehicle:
• Apply the service brake, put the key in the key switch and turn the direction selector to the correct direction.
• Slowly press the accelerator pedal to start the motor.
• When the accelerator pedal is released, the motor decreases the speed of the vehicle. To stop the vehicle
quickly, press the service brake pedal.
When the direction selector is in the reverse position, a warning signal activates to indicate that the vehicle is ready to

Starting Vehicle on a Hill

The parking brake will activate automatically when the vehicle comes to a stop. To start the vehicle on a hill, press the
accelerator pedal and the parking brake will be released.

Coasting

Uncontrolled coasting does not occur with this vehicle. However, this is not a substitute for the brake which should be
used to slow the speed of the vehicle quickly.
This vehicle is equipped with a feature (pedal-up braking) that slows the vehicle's speed when the accelerator pedal is

Labels and Pictograms

The vehicle has labels with pictograms to supply information or warnings. Refer to the SAFETY section of this manual for
the description of the labels.
OPERATING PROCEDURES
run in the reverse direction.
released, until the vehicle stops.
Owner's Guide
B
29