Seat Belts - Cushman LSV 800 INTL Owner's Manual

Read all of SAFETY and this section before attempting any procedure. Pay particular attention to Notices, Cautions, Warnings and Dangers.
• Use a dedicated 15-amp circuit for each battery charger, DO NOT permit other appliances to be plugged into the
receptacle when the charger is in operation.
• Operate the charger in accordance with E-Z-GO's recommendations or applicable electrical codes.

SEAT BELTS

All occupants in the vehicle must have their seat belts properly fastened.
Be sure the seat belts are latched securely and are not twisted.
Position the shoulder belt across the top of the shoulder. Do not place the shoulder belt under the
Loose fitting safety belts significantly reduce protection. Keep belts snug and positioned low on
Do not exceed the recommended number of occupants for the vehicle;
The driver and all passengers must wear seat belts, one person per belt. The two-passenger LSV 800 has two seats and
is equipped with two safety belts, one for the driver and one for the passenger. The safety belts must be used at all times
while operating the vehicle.
This vehicle has not been tested for use with automotive style child safety seats or booster seats.
Do not use automotive style child safety seats or booster seats with this vehicle.
Inspect the safety belt webbing and hardware periodically. Check for cuts, frays or loose parts. Replace com-
Keep safety belts clean and dry. To clean, use mild soap and warm water. Do not use bleach, dye or abrasive
Periodically check for smooth operation and replace if the mechanism is not operating properly.
Pregnant, disabled, or injured persons should consult their doctor for specific recommendations before
Each seat is designed for one occupant only.
ponents if excessive wear or damage is found.
cleaners as this will weaken the belt webbing material.
Do not insert any objects into the retractor mechanism.
using the LSV 800.
Owner's Guide
arm.
the hips.
SAFETY
B
5