Transporting Vehicle; Hauling; In Case Of Total Power Loss - Cushman LSV 800 INTL Owner's Manual

MAINTENANCE
Read all of SAFETY and this section before attempting any procedure. Pay particular attention to Notices, Cautions, Warnings and Dangers.

TRANSPORTING VEHICLE

Hauling

To reduce the possibility of severe injury or death while transporting the vehicle:
Secure the vehicle and contents.
Never ride on the vehicle being transported.
The vehicle must be transported in the forward-facing position.
Maximum speed while hauling the vehicle is 70 mph (112 kph).
If the vehicle is to be transported at highway speeds, the seat bottom and controls must be secured. Always check that
the vehicle and contents are adequately secured before transporting. The rated capacity of the trailer or truck must
exceed the weight of the vehicle (see GENERAL SPECIFICATIONS for vehicle weight) and the load plus 1000 lbs.
(454 kg). Secure the vehicle using ratchet tie downs.
In the event that the vehicle will not move in forward or reverse, the parking brake can be released using the run/tow
switch located under the seat on the passenger side. With the switch toggled to the TOW position and the key switch
in N (neutral) position, the vehicle will roll freely without activating the reverse warning beeper or damaging the con-
troller and motor. After moving the vehicle, return the run/tow switch to the RUN position; leaving the switch in the
TOW position will drain the batteries.

In Case of Total Power Loss

In case of total power loss and the run/tow does not release the parking
brake, refer to the instructions below the controller splash shield. Chock
the tires to prevent the vehicle moving when the brake is released.
Run Tow Switch
Splash Shield
To access the instructions remove three re-usable plastic rivets securing the controller splash shield
to the body and the controller. To remove the re-usable rivets, press the center of the rivet with the
vehicle key, when the center pin snaps into place, the rivet can be removed. Repeat the process for
each remaining rivet. Turn the splash shield over to reveal the instructions for releasing the parking
brake.
To reinstall the controller splash shield, position the splash shield by aligning the mounting holes
with the holes in the body. Push the center pin of each rivet upward so that the top of the pin is
above the rivet head
40 Owner's Guide