Settings Screen; Changing The Fan Settings - AMX ENV-VST-C Instruction Manual

8. Press Mode/Select to change the Humidify setting, then use the navigation buttons to indicate the humidity setpoint you
want. This option is only available if you have the Humidification System active.
9. Press Mode/Select to change the Dehumidify setting, then use the navigation buttons to indicate the dehumidity setpoint you
want. This option is only available if you have the Dehumidification System active.
10. With Exit selected, press Mode/Select to accept the new settings and return to the Main screen.

Settings Screen

The Settings screen (FIG. 28) enables you to establish settings for the fan and filter, and enables you to switch between heating and
cooling. You can use the navigation buttons to move through the highlighted options. The Mode/Select button selects the
highlighted item. You can then use the navigation buttons to change the setting of the highlighted option. Pressing Mode/Select
again highlights the next available option.
Settings screen
FIG. 28
The following table lists the options on the Settings screen:
Settings Screen Options
HVAC Mode
Fan Mode
Fan Speed
Filter Reminder
Advanced Setup
Exit

Changing the Fan Settings

The thermostat has two separate settings to configure the fan on your HVAC system. You can use the Fan State option to set the
fan state to On, which runs the fan continuously, or Auto, which runs the fan when the heating and cooling settings determine it
should do so. You can also set the Fan Speed option to Low, Medium, or High. Perform the following steps to change the fan
settings:
1. On the Main screen, press Mode/Select until the Thermostat Mode screen appears (FIG. 24).
2. Use the navigation buttons to select Settings, and press Mode/Select. The Settings screen appears (FIG. 28).
3. Press Mode/Select to select Fan State.
4. Use the navigation buttons to toggle the Fan State between On and Auto.
5. Press Mode/Select to select Fan Speed.
6. Press Mode/Select to toggle the Fan Speed between High, Medium, or Low.
NOTE: If you are unable to change the fan settings, make sure the fan lock is not turned on. See the Locking the Fan Settings section
on page 36 for more information.
ENV-VST-C - Instruction Manual
Toggles the heat or cool selection between Off, Auto, Heat, and Cool. The Emergency Heat option also appears here if
your thermostat is configured to operate with a heat pump. You can also change the HVAC mode on the main screen.
See the Changing the Heating/Cooling Mode section on page 21 for more information.
Toggles the fan state between On and Auto. You can also change the HVAC mode on the main screen. See the
Changing the Fan Mode section on page 22 for more information.
Toggles the fan speed between High, Medium, and Low.
Enables you to indicate how often you want the thermostat to remind you that the filter for your HVAC system needs
to be changed. You can choose from 30, 60, 90, 120, 150, and 180 days.
• When you enable the Filter Change Reminder feature, the thermostat monitors the number of calendar days since
the feature was set.
• When the operation time reaches the selected number of days, a filter change reminder icon displays to alert you to
change the filter.
Enables you to access more advanced features of the thermostat. Selecting Advanced Setup opens the Security Code
Input screen. See Security Code Screen on page 29 for more information.
Saves all settings and returns to the main screen.
Setup and Configuration
27