Changing The Heating/Cooling Mode; Turning Off The Hvac System - AMX ENV-VST-C Instruction Manual

Perform these steps to change the Hold mode:
1. On the Main screen, hold Mode/Select for three seconds. The Hold Mode menu appears.
2. Use the navigational buttons to select the option you want.
3. Press Mode/Select to activate the selected mode.

Changing the Heating/Cooling Mode

You can access Heating/Cooling mode by holding Mode/Select for three seconds while on the Main screen until the Hold Mode
menu opens. With the Hold Mode menu open, press Mode/Select one time and a menu with heating/cooling options appears. You
can use the navigational buttons to scroll through the list. You can also change the H/C mode on the Settings screen.
Heating/Cooling Mode menu
FIG. 19
The Heating/Cooling Mode options enable you to toggle the HVAC system setting between heating and cooling. The change takes
effect when you press Mode/Select or after a 10-second timeout.
Heating/Cooling Mode Options
Emergency
Auto
Off
Heat
Cool
Perform these steps to change the heating/cooling mode:
1. On the Main screen, hold Mode/Select for three seconds. The heating/cooling menu appears.
2. Use the navigational buttons to select the option you want.
3. Press Mode/Select to activate the selected mode.
NOTE: Do not use air conditioning when the outdoor temperature is below 50° F (10° C).

Turning Off the HVAC System

Perform the following steps to turn off the HVAC system:
1. On the Main screen, hold Mode/Select for three seconds. The Hold Mode menu appears.
2. Press Mode/Select to open to the Heating/Cooling mode menu.
3. Use the navigation buttons to select Off, and press Mode/Select to turn the HVAC system off. The Fan Mode settings appear,
but you do not need to change them. The settings disappear after a 10-second timeout.
ENV-VST-C - Instruction Manual
Toggles the emergency heat setting between On and Off. This option is only available on Heat Pump systems.
Runs the heating or cooling systems when the heating and cooling settings determine it should do so. Pressing either of the
navigational buttons causes the most recently used setpoint to start blinking. While the setpoint is blinking, you can use
the navigational buttons to increase or decrease the setpoint. Pressing Mode/Select while either setpoint is blinking causes
the current setpoint to stop blinking and the other setpoint to start blinking. After a timeout of 10 seconds the setpoint
stops blinking.
Turns off the HVAC system. The heat and cool setpoints do not appear on the Main screen in Off mode.
Activates the heating system using the heat setpoint. Pressing either of the navigational buttons while on the Main screen
causes the heat setpoint to start blinking. While the setpoint is blinking, you can use the navigational buttons to increase or
decrease the heat setpoint. After a timeout of 10 seconds the setpoint stops blinking.
Activates the cooling system using the cool setpoint. Pressing either of the navigational buttons while on the Main screen
causes the cool setpoint to start blinking. While the setpoint is blinking, you can use the navigational buttons to increase or
decrease the cool setpoint. After a timeout of 10 seconds the setpoint stops blinking.
Setup and Configuration
21