Establishing Daytime/Nighttime Temperature Settings; Copying Programmed Settings - AMX ENV-VST-C Instruction Manual

Program Screen Options (Cont.)
Cool
Time
Humidify
Dehumidify
Copy To
Next Day
Exit

Establishing Daytime/Nighttime Temperature Settings

Perform these steps to establish daytime/nighttime temperature settings for program mode:
1. From the Main screen, press Mode/Select to access the Thermostat Mode screen (FIG. 24).
2. Use the navigation buttons to select Program, and press Mode/Select. The Program screen appears (FIG. 25).
3. Use the navigation buttons to select a period of the day for which you want to program temperature settings.
4. Press Mode/Select after you select the appropriate period of the day.
5. Use the navigation buttons to select the heat setpoint you want for that time of day, and press Mode/Select.
6. Use the navigation buttons to select the cool setpoint you want for that time of day, and press Mode/Select.
7. Use the navigation buttons to select the hour in which you want these settings to take effect, and press Mode/Select.
8. Use the navigation buttons to select the minutes in which you want these settings to take effect, and press Mode/Select.
9. Use the navigation buttons to select the time of day (AM/PM) which you want these settings to take effect, and press Mode/
Select.
10. Repeat steps 5 through 10 for each appropriate section of the day.
NOTE: You can only set the Humidify and Dehumidify settings if you have the Humidif ication System and Dehumidif ication
System options turned on in the Advanced Setup options. See the Advanced Setup Screen section on page 37 for more
information.
11. Use the navigation buttons to select Dehumidify, and press Mode/Select.
12. Use the navigation buttons to indicate the new dehumidify settings, and press Mode/Select.
13. Use the navigation buttons to select Humidify, and press Mode/Select.
14. Use the navigation buttons to indicate the new humidify settings, and press Mode/Select.

Copying Programmed Settings

To make it easier to program the thermostat, you can create settings for one day and copy the settings to every following day for
the entire week. Perform the following steps to copy programmed settings:
1. On the Program screen, use the thermostat to set the times and setpoints for a full day. See the Establishing Daytime/
Nighttime Temperature Settings section on page 25 for more information.
2. Use the navigation buttons to select Copy To, and press Mode/Select. The settings for the next day of the week appear
(FIG. 26).
Copy To screen
FIG. 26
ENV-VST-C - Instruction Manual
The level of desired coolness for the HVAC system during the selected period.
The time of day when you want the period to begin and the heat and cool setpoints to take effect.
The desired humidify level for the HVAC system. This option is only available if you have the Humidification System option
turned on in the Advanced Setup options.
See the Advanced Setup Screen section on page 37 for more information.
The desired dehumidify level for the HVAC system. This option is only available if you have the Dehumidification System
option turned on in the Advanced Setup options.
See the Advanced Setup Screen section on page 37 for more information.
Copy the settings from the one day of the week to any or all of the other days.
Select the next day of the week.
Exit the Program Mode Setting screen and return to the Thermostat Mode screen.
Setup and Configuration
25