Advertisement
Duplicator Functions
The duplicator has three menu sections: The Main menu, Setup Options, and
Advanced Setup Options. Setup Options is accessed through the Main
menu. Advanced Setup Options is accessed by holding the ESC button from
any other menu until the unit beeps.
Main Menu
1. Copy HDD
Scans the ports, then copies from the source to any targets found.
2. Async Copy HDD
Scans the ports, then copies from the source to any targets found. More
drives may be added before the process is complete, they will begin the
process as soon as they are detected.
3. Compare HDD
Scans the ports, then any targets found will be compared to the source.
4. Async Compare
Scans the ports, then any targets found will be compared to the source. More
drives to compare may be added before the process is complete, they will
begin the process as soon as they are detected.
5. PreScan Source
Reads all blocks on the source drive to confirm no I/O errors are encoun-
tered.
6. ReScan BUS
Manually scans all ports and reports how many units were found.
7. Source Size
Examines the source drive and reports total space and space used, if drive
contains compatible partitions. Press up/down to change display, ESC to exit.
8. Secure Erase
Scans all ports, then erases all data on all connected drives.
NOTE:
some drives will remain in a locked state when the process is complete. Drives that are
locked may not appear to an operating system and will cause an I/O error if used as a target in
the duplicator. If this happens, start secure erase again and hold ESC to cancel the operation a
few moments after it begins.
www.addonics.com
Technical Support (M-F 8:30am - 6:00pm PST)
Phone: 408-453-6212
Email: www.addonics.com/support/query/
Advertisement
