Advertisement
The Duplicator Panel
There are four buttons and an LCD on
the panel of HDD Duplicator.
1. LCD shows a function or a
message.
2. Use to scroll up function menus.
3. Use to scroll down function menus.
4. Use to execute a function.
5. Use to cancel a function.
Duplicating a drive
When the duplicator powers on, it initializes and goes through the steps
below.
Shows the firmware version
HD Duplicator
1-1 Ver:
Detect Drive's Status
Detect Drives
Copy HDD copies data directly from the source hard disk to the target hard
disk. Press ENT button to begin copy. The system will auto-detect the
hard disks and show the following info on the LCD.
Copy-36 MB/s 0%
235.7GB
The LCD will show the following info during the copying process: remaining
time, completed percentage. The copy speed, capacity and time will vary
depending on the source hard disk. Once the copying process is complete
the LCD will display the following results.
Copy HD
OK:
www.addonics.com
1 : 48
Technical Support (M-F 8:30am - 6:00pm PST)
Duplicator Panel
Initialize SDRAM's Status...
Initialize SDRAM
Shows the first function
1: Copy HD
Phone: 408-453-6212
1
2
4
ENT
ESC
3
5
Email: www.addonics.com/support/query/
Advertisement
