Advertisement
1
2
3
4
5
HDUS4SNDX-A
Installing drives into the 1:4 Snap-In Duplicator
Step 1. Be sure the lock on each drive door is in an unlock position. If not,
use the key that comes with the disk Array to unlock the drive door. Pull on
the door lever to swing open the drive door all the way.
Step 2. Slide a 3.5" SATA hard drive into the drive slot with the drive connec-
tor side facing in. Be sure to orient the hard drive correctly as shown in the
yellow label on the inside of the drive door – with drive door swing open at
the bottom, the top of the hard drive should face to the right. The drive should
slide all the way into the slot with very little resistance. Forcing the drive
into the slot will cause drive damage or permanent damage to the Disk Array.
Step 3. Once the drive is all the way into the drive slot, close the door all the
way till the drive door latch securely. This will engage power and data
connection with the hard drive. The LED lit for the drive slot should lit if the
Disk Array already powered on. You may lock the drive door with the key
Step 4. To remove the hard drive from the Disk Array, simply follow the step 2
– 3 in reverse.
Connecting the Power Cable and Powering On
a. Connect the power cord provided from the wall outlet to the back of the
tower.
b. Turn on the main power switch on the rear of the chassis.
www.addonics.com
Overview
1. LCD Management Console
2. Door Lock
3. Source Drive
4. Target Drives
5. Drive Power & Activity LED
Technical Support (M-F 8:30am - 6:00pm PST)
Phone: 408-453-6212
Email: www.addonics.com/support/query/
Advertisement
