Sym Track Runner 200 Service Manual page 93

8. V-BELT DRIVING SYSTEM/KICK STARTER
Installation
Caution
Pull out driven face to avoid it closing.
Cannot oppress friction plate comp in order
to avoid creates the distortion or the
damage.
Install driving belt onto driven pulley.
Install the driven pulley that has installed the belt
onto drive shaft.
On the drive belt another end to the movable drive
face.
Install the clutch outer with universal holder, and
then tighten nut to specified torque value.
Torque value: 5.0~6.0kgf-m
Install the drive face with universal holder, and
then tighten nut to specified torque value.
Torque value: 5.0~6.0kgf-m
8-6
To this chapter contents
Drive belt
Friction plate comp
Universal holder
Universal holder
Driven face
Nut