Sym Track Runner 200 Service Manual page 110

To this chapter contents
9. FINAL DRIVING MECHANISM
Gear box side
Inner bearing puller
Use inner bearing puller to remove the final shaft
needle bearing, gear shift shaft bearing and
counter shaft bearing from the cover inner side.
Special tool:
Inner bearing puller
Remove cir clip of final shat out side bearing. Cir clip
Remove final shat out side bearing.
Inner bearing puller
Special tool:
Inner bearing puller
Remove oil seal from gear box cover and discard
the seal.
Install new bearings into gear box cover inner
Bearing driver
side.
Special tool:
Needle bearing driver (4905)
Bearing driver (6302)
Bearing driver (6204)
Install new final shaft oil seal into gear box cover,
and then install new out side bearing.
Special tool:
Oil seal driver (30x40x5)
Bearing driver (6205LU)
9-9