Sym Track Runner 200 Service Manual page 65

To this chapter contents
5. ENGINE REMOVAL
Removal of Engine Hanger Bush
Bush
Check if engine hanger bush for damage.
Remove the engine hanger bush, must be
disassemble crankcase and transmission cover
first.
Pressing out
If engine hanger and the rear cushion rubber bush
damaged. Then, with the bush remover / presser,
Ø 30mm, to press the bush out, and replace it with
new one.
Engine hanger bush: ψ 30mm
Place the detent section of the bush remover
toward the bush, and drive both the pressing ring
and bolt in to press the bush out.
Pressing In
Place the flat section of the remover toward the
bush, and then drive the bush, pressing ring, and
bolt in to install the bush.
5-6