Sym Track Runner 200 Service Manual page 106

Remove the drive shaft.
In order to avoid damaging the crankcase, in the
cover place a rag between the case and table.
Check drive shaft and gear for wear or damage.
Special tool:
Shaft protector
Caution
If non- essential do not remove the drive
shaft from the case upper side.
If remove the drive shaft from the gear box,
then its bearing and oil seal has to be
replaced.
Remove the final shaft cir clip and washer.
Remove the final shaft.
To this chapter contents
9. FINAL DRIVING MECHANISM
Oil seal
Washer
Bearing
Cir clip
9-5