Table of Contents
Advertisement
OPERATING INSTRUCTIONS
NOTE: Before using the tool, read the
instruction book carefully.
Intended Use
The machine is intended for impact drilling in brick,
concrete and stone as well as for drilling in wood,
metal and plastic.
1. ON/OFF SWITCH
Depress to start and release to stop your tool.
2. SWITCH LOCK-ON BUTTON
Depress on/off switch (5) then lock on button (6)
(See Fig. 1), release on/off switch first and lock-on
button second. Your switch is now locked on for
continuous use. To switch off your tool just depress
and release the on/off switch.
3. FORWARD AND REVERSE ROTATION CONTROL
For drilling and screwdriving use forward rotation
marked " " (lever is moved to the left). Only use
reverse rotation marked " " (lever is moved to the
right) to remove screws or release a jammed drill bit
(See Fig. 2).
Never change the direction of rotation when
the tool is rotating, wait until it has stopped.
4. AUXILIARY HANDLE
Slide the handle onto the drill and rotate to the
desired working position. To clamp the auxiliary
handle rotate the handgrip clockwise. To loosen the
auxiliary handle, rotate the hand grip anti-clockwise.
Always use the auxiliary handle (See Fig. 3).
5. DEPTH STOP
Fit the drill bit or driver bit into the chuck. Loosen
the depth stop by rotating the handle grip anti-
clockwise. Slide the depth stop until the distance
between the depth stop end and the drill/driver bit
end is equal to the depth of hole/screw you wish to
make. Then clamp the depth stop by rotating the
handle clockwise.
6. HAMMER OR DRILLING CONTROL
When drilling masonry and concrete, choose the
Hammer position
.When drilling wood, metal,
plastic and screwdriving choose the Drill position.
(See Fig. 4)
900W PERCUSSION DRILL
5
Fig. 1
Fig. 2
Fig. 3
Fig. 4
6
Advertisement
Table of Contents
