Function (X, Y) Table Calculation - Canon X Mark I Pro User Instruction

The following operations are not supported by the Coefficient
Editor: ,
multi-statements also cannot be input with the Coefficient Editor.
Press to return the Coefficient Editor while the solutions are
displayed.
Values cannot be converted to engineering notation on the solution
screen.
Special Solution Display
"All" appears on the solution screen when the solution of an
inequality is all numbers.
EX #65
2
Example: x ≥ 0 ......
"No-Solution" appears on the solution screen when no solution
exists for an inequality (such as x
2
Example: x + 3 ≤ 0 ......
Ratio Calculation
Press (RATIO) to enter the RATIO mode. Press
or to select the ratio type.
On the Coefficient Editor screen, input up to 10 digits for each of
the required values (a, b, c, d).
• To solve 3:8=X:12 for X, for example, press
then input the following for the coefficients (a=3,b=8,d=12):
3 8 12 .
Example: To calculate the ratio 2: 3 = 5: X ......
, . Pol, Rec and
2 < 0)
EX #66
in step 1, and
EX #67
The following operations are not supported by the Coefficient Editor.
, ,
multi-statements also cannot be input with the Coefficient Editor.
[Math ERROR] will occur if a calculation is performed while 0 is
input as a coefficient.

Function (x, y) Table Calculation

Input f(x) function to generate the function table for x & f(x).
Steps to generate a Number Table
1. Press to enter the Table function calculation.
2. Function Input screen
• Input function with X variable (
the Function Table Result.
• All other variables (A, B, C, D, Y) and independent
memory (M) act as the value.
• Pol, Rec, Q...r, S,
Function Input screen.
• The Function Table Calculation will change X-variable.
3. The input the start, end, & step information
• Input the value, press
screens
• Input expression and display result value in following
screens are in Line mode status
• There is a maximum of 30 x-values in the function table
generation. "Insufficient Error" will be shown if the start, end,
step value combination is more than 30 x-values.
Display screen
Start? Input the lower limit of X (Default =1).
End? Input the upper limit of X (Default = 5).
*End value must be greater than the start value.
Step? Input the increment step (Default =1).
25
, Pol, Rec and
) to generate
d
functions can not be used in the
dx
to confirm on the following
You should input:-