Defective Zone Bypass; Impact Sensor & Bypass; Smart Arming Delay; Panic - Mongoose M30 Owner's Operation Manual

DEFECTIVE ZONE BYPASS

If any door, the bonnet or boot has been left open when arming, the siren will chirp 3 times as a warning. The open
circuit will then be bypassed if not closed and arm after 10 seconds.
An intrusion via a bypassed circuit will not trigger the alarm.
IMPACT SENSOR - 2 STAGE
The sensor is designed to detect vibrations such as an impact, vehicle towing causing shock, or glass breakage
caused by hitting. It may also be triggered by shock waves produced from loud exhausts, thunder and heavy vehicle
traffic. It is not normally triggered by normal wind or rocking motions. If the sensor receives a light impact the siren
fast chirps for a few seconds. It sounds fully for 15 seconds if it detects a heavier impact.
The sensitivity level is set by the installer and should be at its optimum. Over sensitivity can cause false alarms. A
trigger of the shock sensor will not sound the siren if it has been bypassed by the remote.
SHOCK SENSOR BYPASS
The shock sensor can be bypassed to prevent false alarms. Arm the system by pressing LOCK and within 5 seconds
press LOCK again. The siren will chirp 5 times to confirm the sensor is bypassed.

SMART ARMING DELAY

When arming, if the shock sensor is detecting shock or impact – such as detecting the door being slammed, the
system will delay arming until the sensor is inactive to prevent a false alarm. However, the immobiliser is instantly
active.
AUTOMATIC RE-SET
The siren will sound for 5 to 30 seconds, depending on the circuit triggered, after which it will stop and reset to the
armed position. It will then re-trigger on the next intrusion or if a circuit was left open.

PANIC

In the event of personal attack, the alarm can be 'panicked' for 15 seconds by pressing the RED button for more than
2 seconds. Press any button to cancel.
6